Design and assemble 3d printed sensor head mount
Due Date: Aug 16, 2022
Contributor Log
Name | Contribution |
---|---|
Austin Huang | Task Manager |
Egor Gorelyy | Owner |
Skills
3D printing
Sensor mount design
Task Description
The sensor head mount is a critical part of the science mechanism that is used to collect soil data
There are three main types of sensors located on this mount:
Soil moisture sensor (SEN0114)
CO2 sensor (SEN0219)
Temperature and humidity sensor (DHT22)
The current sensor head designed in CAD is incomplete (MR22-SC-A0036)
Sensor head parts are interfering with the main assembly, and all of the sensors may not be oriented properly with respect to soil samples
The sensor head should complete the following functions:
Allow the dinolite microscope camera to be rotated and refocused
Allow the moisture sensor to collect data from the soil
Allow the C02 sensor to collect data from soil
Allow the temperature and humidity sensor to collect data from the soil
The owner of this task would be responsible for redesigning the sensor head mount and ensuring all functions above are possible.
Task Breakdown
Prerequisites
N/A
Progress Journal
Sep 10, 2022 @Austin Tailon Huang
Task created
Oct 4, 2022 @Egor Gorelyy
Waiting to get clarifications from the science lead on whether the DHT 22 sensor and CO2 sensor can be inserted right into the soil or only lowered near it
Oct 25, 2022 @Egor Gorelyy
There was unclearness on the Science subteam as to whether the sensor needed to be submerged in soil or could detect from close proximity
Same unclearness also about whether it has to be in a vacuum (or sealed environment) or not
Hooked up CO2 sensor to an Arduino, and did some preliminary tests. Asked science lead to come in at some point and test.
Nov 15, 2022 @Egor Gorelyy
Designed a design for how each sensor will be applied and created some designs for the entire sensor head
Had the preliminary design review for the project
Dec 21, 2022 @Egor Gorelyy
The sensor head CAD has been modified to effectively fit all the sensors but still needs to be printed
All the components can be found in the DF Robot box
The sensor head needs to be tested: if the sealing on the CO2 sensor is not enough an o-ring could potentially be used to seal it more effectively
The sensor head is a little hard to attach to the flange due to the available bolts' length
Relevant Documentation Links