Introduction

Please watch these videos and read the entire manual before attempting to set up a tripod https://www.youtube.com/watch?v=O3Dp1kjI8gY

https://www.youtube.com/watch?v=HjwDyNAidWM

This will ensure the safety of the tripod and all equipment fixed on top of the tripod

Important take-aways (for those who don’t read)

• Ensure the tripod legs are spread evenly apart.
• Ensure the tripod legs are not too far apart or too close together
• Ensure the legs of the tripod are firmly planted in the ground
• Ensure the tripod is an an appropriate height
• Ensure the top of the tripod is level
• Ensure the quick releases and screw tighteners are fully locked before securing any payload. This is important for heavy payloads

Setting up in dirt/gravel/sand

Same setup as shown in the video.

Stomp on each of the legs into the ground.

Test the tripod to ensure the legs will not kick out.

Make sure the tripod is secure in the ground before securing any of the base-station equipment to the tripod.

Leg strap is not required if legs are firmly in place.

Setting up on smooth surfaces

Anything on which the tripod legs can easily slip is considered a smooth surface for the purpose of this document.

Sidewalk may be considered smooth depending on the environment

Take advantage of cracks where possible. Getting a tripod leg in a crack will prevent any potential slippage if utilised correctly.

Drill holes in the ground. Drilling a ½” divot to seat a tripod leg is also a great way to set up a sturdy tripod, but not always an option.

Use the inside leg strap. The strap forms a loop with 3 clips that attach to each leg. It prevents the legs from kicking out but increases setup time. The leg strap is also a bit finicky and limits how far the legs can spread out.