Goals
- Catch any issues with the proposed gimbal design and see what else can be changed to improve it.
Update & Action Items
Member | Update | Action Items |
---|---|---|
Caleb |
|
|
New Tasks
General Notes
add looseness so that alignment is not an issue
over size clearance holes
another piece used for allignment on the U piece, not the U piece itsself
limitation might not be the inertia, but the friction instead
- maybe make the top part milled
remove top piece - top piece to shield from sun
top flange increases stiffness, C channel?
remove all that space between the bushings on the side
clevis pins are not great for controlling length
metal super market for C channel?
the main U bracket -> C channel?
if stick to sheet metal make top part flat for fixturing
zip tie wire management is sick - very good
lock washer for the fasteners? torque make bring them off
vibration reduce preload on fasteners - try to inhibit this loctite or lock washer
slit lock washers suck, dont work well
where to mount pcb?
where there is least movement
at the bottom
mount at source so wire harness is smaller
right at bottom of motor
bottom of the 3D printed U part (on temp mount)
if it was only spinning +- 90, would put on theĀ
more relief around the bends on the camera bracket -> to give demtool more space to bend
this is so they have space to stick their tool in better
make more space on the bottom so it doesnt start at the edge (so it doesnt peel up)
RELIEF CUTS -> for when a bend is not the full length of the base
rotational bend off the mounting of the camera NOT the back of the camera
one less bend between mounting on rotation
remove top flange completely, different sun shield?
change shape to bottom U, no backing need, no top needed, simplier -> 2 bends only