- What are optimal linkage lengths for the robotic arm?
- How did you optimize the payload to weight ratio?
- What was the reasoning behind using worm gear in the end effector?
- Are you familiar with the iteration of the arm design where belts were used? If so how did the belts perform and why were the belts removed in the following iterations?
- Why were bushings used on the motor shafts?
- Why were differentials used?
- What are your thoughts on using a tubular approach for the arm frame?
- Any recommendations on dealing with backdriveability of the cycloid/planetary drives used in the current arm design? How would you prevent the arm from “flopping around” when it is in its rest position?
Manage space
Manage content
Integrations