...
- Wheel integration!!!
- To do ASAP!
- Get more detail on the inner fillet of the wheel so that we have more information on the constraining area
- Print the current wheel hub and test ASAP
- Consider alternative methods, such as adapting the original hub → Asha Mills Emmett
- To do ASAP!
- Prototype bonding aluminum hubs to the carbon fibre
- Verify choice of epoxy
- Verify successful establishment of the bond gap between the aluminum and carbon fibre
- Verify by testing the strength of the carbon fibre assembly after bonding using the Department's equipment
- To do ASAP!:
- Buy bonding materials from Composites Canada
- Get a cap machined
- Add bonding step
- Develop a test plan and establish what we are specifically looking for (Instron?)
- Questions:
- How much material do we have left? → Chanpakorn Chaiklahan
- Approximately 3 ft., enough for another test.
- FEA!!! → Andrew Tersigni (Deactivated)
- Smaller CAD updates
- Refer to the review's meeting minutes for specific feedback on each sub-system
- General feedback:
- Reduce the amount of hardware needed → PEM nuts, flange bolts, reduce overkill of mounting locations, remove unnecessary 3D printed parts
- Reduce areas of stress concentration!
- Verify machinability with Demtool's guidelines
...