Preliminary Architecture design
Functional architecture
Top level Vehicle
Overall Requirement statements, Generated by project stakeholders (This still needs to take place):
Can be found in 0.0 Rocket Requirements and Specification
ConOPS Stages
These are the distinct states of rocket operations.
1.0 Assembly - 2.0 Ground functions - 3.0 Launch - 4.0 Powered Flight - 5.0 Coast - 6.0 Apogee Events - 7.0 High velocity Descent - 8.0 Low altitude Events - 9.0 Low velocity Descent - 10.0 Landing - 11.0 Recovery & Disassembly
Each stage can be broken down further into nominal (NX.X.X) and Off-nominal (EX.X.X) Steps. This is described in system-level functional-flow block diagrams for each stage
Physical architecture
Break top level vehicle into the following subsections - Based on physical location
Each subsection is assigned a Section number S#.
S# | Bounds & Interfaces | Spec Document | Section Owner | |
|---|---|---|---|---|
R0.0 | Rocket (Highest Level) | |||
1.0 | Recovery System | All Parts from tip of nosecone to the Recovery bulkhead & Electronics sled. | ||
1.1 | Nosecone | |||
1.2 | Shear-pin coupler | |||
1.3 | Parachute Tube | |||
1.4 | Parachute & Rigging | |||
1.5 | BigRedBee System | Matti Gencher | ||
1.6 | Recovery Electronics Sled | Stefan Arroyo-Cottier | ||
1.7 | Flight Computer System | |||
1.8 | Live-Telemetry System | |||
1.9 | CAN-Power Management System | |||
2.0 | Cubesat Payload | |||
2.1 | Payload Structure | |||
2.2 | Payload Experiment | |||
3.0 | Upper Airframe | |||
3.1 | Upper Bodytube | |||
3.2 | Payload Retention Structure | |||
3.3 | Camera System | |||
4.0 | Tank Vent System | |||
4.1 | Pressure Relief Systems | |||
4.2 | Vent Valve & Actuator | |||
4.3 | Vent Pneumatics | |||
4.4 | Vent Electronics | |||
5.0 | Oxidizer Tank | |||
5.1 | Raceway | |||
5.2 | Ox Tank | |||
6.0 | Ox-Tank-Aft-Skirt (OTAS) | |||
6.1 | Longerons | |||
6.2 | Fairings | |||
6.3 | Fill Disconnect Hatch | |||
7.0 | Injector Feed System | |||
7.1 | Injector Valve | |||
7.2 | Injector Electronics | |||
7.3 | Ox Fill Disconnect line | |||
8.0 | Combustion Chamber | |||
8.1 | Injector bulkhead Assembly | |||
8.2 | Fuel & Chamber Assembly | |||
8.3 | Nozzle Assembly | |||
9.0 | Fins & CC Airframe | |||
9.1 | Fin body | |||
9.2 | Boat-Tail | |||
9.3 | Nozzle Interface | |||
10.0 | Electrical Harness | |||
10.1 | Recovery Harness | |||
10.2 | Upper Section Harness | |||
10.3 | OTAS Harness | |||
G0.0 | Launch GSE (Highest Level) |