Reviewer Name	Manufacturer Part Number	Symbol Name	Footprint Name	Comments
Rayyan Mahmood	NCV8114ASN180T1G	NCV8114ASN180T1G	1.8V_Output_LDO	Need a revision of the TVS diode and the terminal block Image Added Essentially a power protection circuit. Saves designer from incorrect connection to connector. Schottky diode blocks reverse current if battery connected opposite way TVS diode prevents transient voltage spikes and clamps if voltage of 6.4V is detected Switch TVS diode for a diode which clamps at about 4V Check the choice of LED Image AddedGood work showing calculations with notes IC is good (both footprint and schematic symbol) LEFT REMAINING COMMENTS BELOW FOR POWER.SCHDOC
Rayyan Mahmood	ICM-20948	IC_9DOF_IMU_W24	ICM20948 - 9DOFIMU	Check the footprint of the IMU since there is a slight different comparing to the rev 1 footprint Need to add the test point/debugging feature later Checking if we need to use the AUX/DA feature since the rev1 does not use it too
Rayyan Mahmood	TXB0104PWR	TXB0104PWR	TXB0104PWR 4-bit directional voltage-level translator	The purpose of this one is changing the 3.3V from the MCU to 1.8V to suit in the IMU Need to use 2 since there are not enough pins to change from only one 4-bit? Maybe find the another one with enough pins if we can? Maybe need a test point just in case there is something wrong with this one

Schematic Sheet Reviews

...

Add a second LED for 1.8V outImage Added
Image Added Change the colour of this title to match the colour of “GND”, “3V3”, etc.
Add test points for 1.8V and 3.3V and a GND test point as well.

Look at the 48-17V buck schematic and see which TPs were used for the power and GND and use the exact same ones here

It is up to the designer’s discretion as to what should be reviewed for each schematic sheet

...

Versions Compared