Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

These are the settings that should be there when you run block builder and assigner. They are found under Tools → Options → Student Assigner

...

Note

 IMPORTANT: Avoid using all special characters, including single and double quotation marks (e.g. “, ‘) in the course combination IDs.

...

In "Secondary Files" under "Course Characteristics" batch edit all course characteristics that represent a Reserve/Course and the “Space” course characteristic and remove the option “Section(s) and/or Component(s) are Available Only to Students Requesting this Characteristic”. Also check the "Marker for them as they will be easier to find later. Don't select any of the "campus" locations - UW, BLND, ONLN

 

...

This is under Secondary files, select all the reserves (not campus types)

...

Under "Tools" run the "Balance Enrollment Based on Demand..." loop with only course combinations as demand until the scheduling vs actual enrolment values look good.

...

Batch edit all course characteristics that represent a Reserve/Course and the “Space” course characteristic and check the option “Section(s) and/or Component(s) are Available Only to Students Requesting this Characteristic”.

...

Check the flag in the course characteristic

Run the Balance Enrollment Based on Demand loop Students, course combinations and academic blocks as demand until the scheduling vs actual enrollment values look good.

...