...
-
L-Bracket for motor mount, milled component for motor mount
This is final design type of issue, for now 3d printed is fine, milled is better because it can hold tighter tolerances -
Take out chamfers of the front and back milled components
Cost little to nothing, some chamfers are essential -
Make the nut carriage simpler to manufacture
costs 100 on fictiv, similar to the other brackets - Ream holes on laser cut pieces
- Add anti-seize to BOM for pin joints
- Add 3/16 id shims to bom
- specify spot welds instead of weld fillet (help retail temper on the sheet metal parts)
-
Misumi shaftmight not be able to get the steps required, or will require a post op -see if this can be machined in house first
a tight tolerance step at the minor diameter of the lead screw is required to interface with the f-loc gear, might bot beable to post op machine that out of an existing screw - Adhesive backed rubber
- Try different rubbers - sorbethane
- add loctite 660 to bom - mcmaster
- redo the spring location - interface is fine but location is wack
- spring calculations and iteration
- make drawings for all of the components
...