...
- Task: Buy 1/4" and 1/8" acrylic sheets for lid and second level laser cutting (to be completed once campus lockdown is over)
Assigned To: Jasmine Milan (or anyone else on campus)
Estimated Completion Date: (when campus lockdown ends) - Task: Get the lid laser cut. DWG in fab folder in GrabCAD (MR21-EB-013-AHu)
Assigned To: Austin Tailon Huang (or anyone else on campus)
Estimated Completion Date: (when campus lockdown ends) - Task: Print the remaining power pole mounting powers (6x MR21-EB-008-JAM)
Assigned To: Austin Tailon Huang
Estimated Completion Date: - Task: Determine if there are issues with the 3D printed hinges, address issues if they arise and get them printed (2x MR21-EB-003-MAG, 2x MR21-EB-004-MAG)
Assigned To: Austin Tailon Huang
Estimated Completion Date: - Task: 3D print the small lid strain reliefs (2x MR21-EB-004-JAM)
Assigned To: Austin Tailon Huang
Estimated Completion Date: - Task: 3D print the large lid strain relief (1x MR21-EB-003-JAM)
Assigned To: amillsem@uwaterloo.ca
Estimated Completion Date: - Task: 3D print the fan finger guards (4x MR21-EB-018-AHu)
Assigned To: Austin Tailon Huang
Estimated Completion Date: - Task: 3D print the custom second level mounting standoffs (2x MR21-EB-017-AHu)
Assigned To: Austin Tailon Huang
Estimated Completion Date: - Task: 3D print the large insulating standoffs for the e-box frame (2x MR21-EB-015-AHu)
Assigned To: amillsem@uwaterloo.ca
Estimated Completion Date: - Task: 3D print spacer for handle latch (1x MR21-EB-014-AHu)
Assigned To: Austin Tailon Huang
Estimated Completion Date: - Task: Update the connector place holders (USB and Ethernet) to reflect actual real life models
Assigned To: Jasmine Milan
Estimated Completion Date: - Task: Update lid and fasteners to use low profiles rather than countersunk flat heads in CAD
Assigned To: Austin Tailon Huang
Estimated Completion Date: - Task: Get vicor model from Andrew and put it in the CAD
Assigned To: Austin Tailon Huang
Estimated Completion Date: - Task: Update the connector place holders (USB and Ethernet) to reflect actual real life models
Assigned To: Jasmine Milan
Estimated Completion Date: - Task: Finalize second level layout and laser cut second layer piece (this needs to be done with electrical in person
Assigned To: TBD
Estimated Completion Date: TBD
...